IX. DIFFERENTIATION OF SYSTEM CONTROL
SCHEMATIC DIAGRAM & P. C. BOARD
X. COMPOSITE VIEWS OF COMPONENTS
Continue Next Section . . .
SCHEMATIC DIAGRAM & P. C. BOARD
1. Because the System Control Schematic Diagram and the P.C. Board are differentiated by serial number, the following (Chart 5) is provided for reference. Accordingly, because System Control P.C. Board KH-1009A, B and KH-1039A, B are not interchangeable, when placing your order, be sure to state the System Control P.C. Board number. 2. When using a KH-1039A, B in a machine employing System Control P.C. Board KH-1009A, B, the following changes are also necessary. 1) Remove the lead wires connected to operation switches SW-14 (RWD), SW-15 (F.FWD), and SW- 1 6 (FWD) from terminals (B1) {B4) and {B10) of the Operation Lamp P.C. Board. 2) Remove the multi-socket terminal [Ll2] lead wire connected to the System Control P.C. Board, and connect terminals [L12] and (B1). 3) Remove the multi-socket terminal [R8] lead wire connected to the System Control P.C. Board, and connect terminals [R8] and (B4). 4) Remove the multi-socket terminal [R2] lead wire and connect terminals [R2] and {B10).
5) Disconnect the various inner components (resistor, capacitor, diode, and transistor) of the Operation Lamp P.C. Board and directly connect Lamps IND-1 through IND-4. | . |
| 33 |
 |
| 34 |
 |
| 35 |
 |
| 36 |
 |
| 37 |
 |
| 38 |
 |
| 39 |
 |
| 40 |
 |
| 41 |
 |
| 42 |
 |
| 43 |
|
THIS PAGE IS BLANK. |
| 44 |